Over-Unity Technology — The Consciousness Factor

Alia’s Comment: I wrote this post in order to emphasize the importance of the consciousness aspect regarding the emergence of over-unity technology. This is not in any way to devalue the technological aspect involved in bringing forth this new energy paradigm , nor is it meant to dishonor or hold in less esteem any of the brilliant engineers and scientists that are working on these projects. I am writing this to state my own viewpoint that mechanical skill alone is not sufficient to make these devices work or to keep them running. There is a consciousness factor that needs to be considered as equally important in the development of these new technologies.  This article addresses the consciousness side of the equation. I have covered as thoroughly as am able the assembly and mechanical functioning of the QEG in several previous posts. I ask technicians and lay persons alike to give the ideas contained herein serious consideration. I believe we are very close to this dual breakthrough mentioned below. Thank you for your time and attention.

I believe that there is a direct relationship between the emergence of advanced technologies, such as “free energy” devices and the reawakening of Oneness in the Collective Human Consciousness. In an earlier post, I spoke of these two aspects of evolution developing in tandem. Personally, I think that the quantum leap in human consciousness will be the catalyst that allows these zero-point or over-unity technologies to materialize. However, it may be a bit like the old riddle, “Which came first, the chicken or the egg?” In other words, I think that these two evolutionary breakthroughs are so inter-related that they will seem to appear simultaneously at some magical moment of NOW.

QEG Assembly — In Pictures

Looking Into the Core of the QEG

The Core of the QEG arrived in Aouchtam on Thursday night late. By Friday mid-day the QEG Workshop was humming with activity.

The photo on the left  shows the four quadrants of the Core. Two sections are considered “primary” or the parts that will produce resonance frequency. The other two sections are called “secondary” and produce output frequency. The Core contains over 300 individual steel plates that are 17.5 1000th of an inch thick, stacked one upon the other and then wrapped in “inverter-duty” grade 10-guage wire. The white covering is additional insulation material. You can see the wrapped wire under this covering. What the Team learned in Taiwan was that the QEG is a high-voltage, low-current generator. They had thought it was the other way around. With this new understanding — that power as high as 25,00 volts could be produced with this device, an third form of insulation (a specific kind of epoxy) was distributed through the wrapped wire by creating a vacuum at one end and “sucking” the epoxy material evenly through the wrapped wires. This extra insulation is a first-time addition to the assembly process.